User Manual

ThingMagic Nano User Guide ii
JADAKtech.com
REVISION HISTORY
Date Version Description
3/2015 01 Draft 1 • Partial Draft for early-access release.
4/2015 01 REV A • First Release for prototype units with 1.3.1 firmware.
4/2015 01 Rev B • Second release for GA units with version 1.3.2
firmware.
• Receive sensitivity values updated (RF
Characteristics)
• Long-term exposure caution updated Regulatory
Support
• Thermal limits explained more fully (ThingMagic Nano
Carrier Board)
• Minor Editorial Changes.
• Minor changes following review by Engineering.
6/2015 01 Rev C • In “Hardware Overview” section, the table of pin
functions erroneously listed pin 39 as both a signal
and a ground and omitted ground pin 37. This has
been corrected.
• The “Host Board Design” section of the “Hardware
Integration” changed. The “landing pads” outline
changed to show heat sink areas. The table that
indicated pad sizes and locations incorrectly was
removed and replaced by a reference to the carrier
board design files.
9/2015 01 Rev D • Ambiguity about whether RX and TX pins are inputs or
outputs clarified.
4/2016 01 Rev E • Content added to reinforce that all GPI lines and the
RX input line must be low when the module boots up
and low when the module shuts down.
6/2017 01 Rev F • References to Trimble removed; Logo changed
• “Authorized antenna” language softened in first
regulatory section to conform with more detailed
constraints later.
• “Authorized antennas” changed to “FCC Authorized
antennas” and EU antenna section added.
• EU RED Declaration of Conformity added.
• Erroneous reference to USB interface removed and
warning put on carrier board schematic that names on
unused pins should not be construed as support .
• Diagram showing wrong pad numbers and
dimensions removed and reference to addendum
document inserted.
• Reference made to expanded multiplexing
capabilities.
• Pin-out table clarified.
• Caveat about switching frequency of supply added.
• Information about region NA3 added.