User Manual

Setup Instructions
1) Thoroughly clean the intended area with soap to remove dirt and oil
2) Snap electrodes to the sensor’s snap connectors
(Note: While you can snap the sensor to the electrodes after they’ve been placed on the muscle, we do not
recommend doing so due to the possibility of excessive force being applied and bruising the skin.)
3) Place the sensor on the desired muscle
a. After determining which muscle group you want to target (e.g. bicep, forearm,
calf), clean the skin thoroughly
b. Place the sensor so one of the connected electrodes is in the middle of the
muscle body. The other electrode should line up in the direction of the muscle
length
c. Peel off the backs of the electrodes to expose the adhesive and apply them to
the skin
d. Place the reference electrode on a bony or nonadjacent muscular part of your
body near the targeted muscle
4) Connect to a development board (e.g. Arduino, RaspberryPi), microcontroller, or ADC
a. See configurations previously shown
Example Sensor Location for Bicep
EMAIL: [e-mail]
www.AdvancerTechnologies.com
© 2015-2016
Note: Not To Scale