Data Sheet

1/26/2018 Setting Up the Pi Zero Wireless Pan-Tilt Camera - learn.sparkfun.com
https://learn.sparkfun.com/tutorials/setting-up-the-pi-zero-wireless-pan-tilt-camera?_ga=2.27217844.824006966.1516918290-204410570.150963225…
5/11
Now fit the shaft of the servo into the fitting on the horn that you previously installed into the base. This is the point
where you need to make sure that the shaft is roughly centered in order for the entire assembly to work properly. I do
this by turning the shaft all the way to one extreme, then turning it 90 degrees back in the other direction. Then, I
remove the base and line it up with the body of the servo motor.
Find the two longer screws that came with the horn kit in the set. There will likely be only two of these, and you need
both, so don’t lose one!