Datasheet-2

a-Si TFT LCD Single Chip Driver
132RGBx162 Resolution and 262K color
ILI9163C
Page 98 of 200 Version:0.09
14.2.6 Read Display MADCTL (0Bh)
0BH RDDMADCTL (Read Display MADCTL)
D/CX RDX WRX
D17-0 D7 D6 D5 D4 D3 D2 D1 D0 HEX
Command 0 1  x 0 0 0 0 1 0 1 1 0Bh
1
st
Parameter 1  1 x x x x x x x x x x
2
nd
Parameter 1  1 x D7 D6 D5 D4 D3 D2 D1 D0 00h
Description
This command indicates the current status of the display as described in the table below:
Bit Description Value
D7 Page Address Order “1”=Decrement, “0”=Increment
D6 Column Address Order “1”=Decrement, “0”=Increment
D5 Page/Column Order “1”=Row/column exchange(MV=1)
“0”=Normal(MV=0)
D4 Line Address Order “1”=LCD Refresh Bottom to Top
“0”=LCD Refresh Top to Bottom
D3 RGB/BGR Order “1”=BGR, “0”=RGB
D2 Display Data Latch Order “1”=LCD Refresh right to left
“0”=LCD Refresh left to right
D1 Switching between Segment outputs and RAM Set to ‘0’
D0 Switching between Common outputs and RAM Set to ‘0’
Register
Availability
Status Availability
Normal Mode On, Idle Mode Off, Sleep Out Yes
Normal Mode On, Idle Mode On, Sleep Out Yes
Partial Mode On, Idle Mode Off, Sleep Out Yes
Partial Mode On, Idle Mode On, Sleep Out Yes
Sleep In Yes
Default
Status Default Value(D7 to D0)
Power On Sequence 0000_0000(00h)
SW Reset No Change
Flow Chart
command
Parameter
Display
Action
Mode
Legend
RDDMADCTR(0Bh)
Sequential transfer
Parallel I/F Mode
RDDMADCTR(0Bh)
Serial I/F Mode
Send D[7:0]
Dummy Read
Send D [7:0]
Host
Driver