Datasheet-2

a-Si TFT LCD Single Chip Driver
132RGBx162 Resolution and 262K color
ILI9163C
Page 36 of 200 Version:0.09
Data Enable (EN) is used to tell when there is received RGB information that should be transferred on the display.
This is a high enable and its state is read to the display module by a rising edge of the PCLK signal. D[17:0] are
used to tell what is the information of the image that is transferred on the display (When EN= ’1’ and there is a
rising edge of PCLK). D[17:0] can be ‘0’ (low) or ‘1’ (high). These lines are read by a rising edge of the PCLK
signal.
VS
HS
PCLK
Moving picture
display area
EN
RAM data display area
Back porch period
Display period
Front porch period
D[17:0]
Note 1: Front porch period continues until
the next input of VS.
Note 2: Input PCLK throughout the
operation.
Note 3: Supply the VS, HS and PCLK with
frequency that can meet the resolution
requirement of panel.
Figure23: GRAM Access Area by RGB Interface