Datasheet-2

a-Si TFT LCD Single Chip Driver
132RGBx162 Resolution and 262K color
ILI9163C
Page 193 of 200 Version:0.09
17. Electrical Characteristics
17.1 Absolute Maximum Ratings
The absolute maximum rating is listed on following table. When ILI9163C is used out of the absolute
maximum ratings, the ILI9163C may be permanently damaged. To use the ILI9163C within the following
electrical characteristics limit is strongly recommended for normal operation. If these electrical characteristic
conditions are exceeded during normal operation, the ILI9163C will malfunction and cause poor reliability.
Item Symbol Unit Value
Note
Supply voltage VCI V -0.3 ~ + 4.8
Supply voltage (Logic) VDDI V -0.3 ~ + 4.6
Supply voltage (Digital) VCC V -0.3 ~ + 2.4
Driver supply voltage VGH-VGL V -0.3 ~ + 33.0
Logic input voltage range VIN V -0.3 ~ VDDI + 0.3
Logic output voltage range VO V -0.3 ~ VDDI + 0.3
Operating temperature Topr °C -40 ~ + 85
Storage temperature Tstg °C -55 ~ + 110
Notes: If the absolute maximum rating of even is one of the above parameters is exceeded even momentarily,
the quality of the product may be degraded. Absolute maximum ratings, therefore, specify the values
exceeding which the product may be physically damaged. Be sure to use the product within the range of the
absolute maximum ratings.
17.2 DC Characteristics
Item Symbol
Uni
t
Condition Min. Typ. Max. Note
Power & Operation Voltage
Analog Operating
voltage
VCI V Operating voltage 2.5 2.78 4.8 Note2
Logic Operating voltage VDDI V I/O supply voltage 1.65 1.8/2.78 3.3 Note2
Digital Operating voltage VCC V Digital supply voltage 1.8 Note2
Gate Driver High voltage VGH V 10.0 16.0 Note3
Gate Driver Low voltage VGL V -16.0 -7.5 Note3
Driver Supply voltage V
VGH-VGL
19 32 Note3
Input/Output
Logic High level input
voltage
VIH V 0.7VDDI VDDI Note1,2,3
Logic Low level input
voltage
VIL V VSS 0.3VDDI Note1,2,3
Logic High level output
voltage
VOH V IOH = -1.0mA 0.8VDDI VDDI Note1,2,3
Logic High level output
voltage
VOL V IOL = 1.0mA VSS 0.2VDDI Note1,2,3
Logic input leakage
current
IIL µA
VIN = VDDI or VSS -0.1 +0.1 Note1,2,3
Sleep in current
consumption
I
SLP
µA
VCI=VDDI=2.8V ,
Ta=25 °C
70 Note1,2,3
VCOM Operation