Datasheet-2

a-Si TFT LCD Single Chip Driver
132RGBx162 Resolution and 262K color
ILI9163C
Page 143 of 200 Version:0.09
14.2.33 Interface Pixel Format (3Ah)
39H IDMON (Idle Mode On)
D/CX RDX WRX D17-8 D7 D6 D5 D4 D3 D2 D1 D0 HEX
Command 0 1  x 0 0 1 1 1 0 1 0 3Ah
1
st
Parameter
1 1  x VIPF3 VIPF2 VIPF1 VIPF0 D3 IFPF2 IFPF1 IFPF0 66h
Description
This command is used to define the format of RGB picture data, which is to be transferred via the MCU
interface. The formats are shown in the table:
Bit Description Value
VIPF3 “0101”=16 bit/pixel (1 times data transfer)
VIPF2 “0110”=18 bit/pixel (1 times data transfer)
VIPF1 “1110”=18 bit/pixel (3 times data transfer)
VIPF0
RGB Interface Color Format
The others = not defined
D3 “0” (Not Used)
IFPF2
IFPF1
IFPF0
Control Interface Color Format “011”=12 bit/pixel
“101”=16 bit/pixel
“110”=18 bit/pixel
The others = not defined
Note
1.In 12-bits/Pixel, 16-bits/Pixel mode, the LUT is applied to transfer data into the Frame Memory.
2. When VIPF[3:0]=1110, 6-bits data width of 3-times transfer is used to transmit 1 pixel data with the 18-bits
color depth information.
X = don’t care
Restriction
There is no visible effect until the Frame Memory is written to.
Register
Availability
Status Availability
Normal Mode On, Idle Mode Off, Sleep Out Yes
Normal Mode On, Idle Mode On, Sleep Out Yes
Partial Mode On, Idle Mode Off, Sleep Out Yes
Partial Mode On, Idle Mode On, Sleep Out Yes
Sleep In Yes
Default
Status Default Value
Power On Sequence
18bit/pixel
SW Reset No change