Datasheet-2

a-Si TFT LCD Single Chip Driver
132RGBx162 Resolution and 262K color
ILI9163C
Page 133 of 200 Version:0.09
14.2.28 Tearing Effect Line On (35h)
35H TEON (Tearing Effect Line ON)
D/CX RDX WRX D17-8 D7 D6 D5 D4 D3 D2 D1 D0 HEX
Command 0 1  x 0 0 1 1 0 1 0 1 35h
1
st
Parameter
1 1  x x x x x x x x M 00h
Description
This command is used to turn ON the Tearing Effect output signal from the TE signal line. This output is not affected by changing
MADCTL bit ML.
The Tearing Effect Line On has one parameter which describes the mode of the Tearing Effect Output Line. (X=Don’t Care).
When M=0:
The Tearing Effect Output line consists of V-Blanking information only.:
tvdl tvdh
Vertical Time Scale
When M=1:
The Tearing Effect Output Line consists of both V-Blanking and H-Blanking information:
tvdl
V-Sync
tvdh
1st
Line
480th
Line
V-Sync
Invisible
Line
Note: During Sleep In Mode with Tearing Effect Line On, Tearing Effect Output pin will be active Low.
Restriction This command has no effect when Tearing Effect output is already OFF.
Register
Availability
Status Availability
Normal Mode On, Idle Mode Off, Sleep Out Yes
Normal Mode On, Idle Mode On, Sleep Out Yes
Partial Mode On, Idle Mode Off, Sleep Out Yes
Partial Mode On, Idle Mode On, Sleep Out Yes
Sleep In Yes
Default
Status Default Value
Power On Sequence Tearing effect off & M=0
SW Reset Tearing effect off & M=0
HW Reset Tearing effect off & M=0