Datasheet-2

a-Si TFT LCD Single Chip Driver
132RGBx162 Resolution and 262K color
ILI9163C
Page 123 of 200 Version:0.09
14.2.23 Color Setting fro 4K, 65K and 262K (2Dh)
2DH RAMWR (Memory Write)
D/CX RDX WRX D17-8 D7 D6 D5 D4 D3 D2 D1 D0 HEX
Command 0 1  x 0 0 1 0 1 1 0 1 2Dh
1
st
Parameter 1 1  x x x R005 R004 R003 R002 R001 R000 -
1 1  x x x Rnn5 Rnn4 Rnn3 Rnn2 Rnn1 Rnn0 -
32
nd
Parameter 1 1  x x x R315 R314 R313 R312 R311 R310 -
33
rd
Parameter 1 1  x x x G005 G004 G003 G002 G001 G000 -
1 1  x x x Gnn5 Gnn4 Gnn3 Gnn2 Gnn1 Gnn0 -
96
th
Parameter 1 1  x x x G635 G634 G633 G632 G631 G630 -
97
th
Parameter 1 1  x x x B005 B004 B003 B002 B001 B000
1 1  x x x Bnn5 Bnn4 Bnn3 Bnn2 Bnn1 Bnn0 -
128
th
Parameter 1 1  x x x B315 B314 B313 B312 B311 B310 -
Description
This command is used to define the LUT for 12bit-to-18-bit color depth conversations 128-Bytes must be written to
the LUT regardless of the color mode.
In this condition, 4K-color(4-4-4), and 65K-color(5-6-5) data input are transferred 6That-6(G)-6(B) through RGB LUT
table.
This command has no effect on other commands/parameters and Contents of frame memory.
Visible change takes effect next time the Frame Memory is written to.
Restriction
Do not send any command before the last data is sent or LUT is not defined correctly.
Register
Availability
Status Availability
Normal Mode On, Idle Mode Off, Sleep Out Yes
Normal Mode On, Idle Mode On, Sleep Out Yes
Partial Mode On, Idle Mode Off, Sleep Out Yes
Partial Mode On, Idle Mode On, Sleep Out Yes
Sleep In Yes
Default
Status Default Value
Power On Sequence Contents of memory is set randomly
SW Reset Contents of memory is not cleared
HW Reset Contents of memory is not cleared
Flow Chart
command
Parameter
Display
Action
Mode
Legend
Sequential transfer
RGBSET(2Dh)
Partial Mode
1st Parameter
:
:
64th Parameter
65th Parameter
:
:
128th Parameter