Datasheet-2

a-Si TFT LCD Single Chip Driver
132RGBx162 Resolution and 262K color
ILI9163C
Page 115 of 200 Version:0.09
14.2.20 Column Address Set (2Ah)
2AH CASET (Column Address Set)
D/CX RDX WRX D17-8 D7 D6 D5 D4 D3 D2 D1 D0 HEX
Command 0 1  x 0 0 1 0 1 0 1 0 2Ah
1
st
Parameter
1 1  x XS15 XS14 XS13 XS12 XS11 XS10 XS9 XS8 -
2
nd
Parameter
1 1  x XS7 XS6 XS5 XS4 XS3 XS2 XS1 XS0 -
3
rd
Parameter
1 1  x XE15 XE14 XE13 XE12 XE11 XE10 XE9 XE8 -
4
th
Parameter
1 1  x XE7 XE6 XE5 XE4 XE3 XE2 XE1 XE0 -
Description
This command is used to define area of frame memory where MCU can access.
This command makes no change on the other driver status.
The values of XS[15:0] and XE[15:0] are referred when RAMWR command comes. Each value represents one column line
in the Frame Memory.
XS[15:0] XE[15:0]
X = don’t care
Restriction
XS [15:0] always must be equal to or less than XE[15:0].
When XS[15:0] or XE[15:0] is greater than maximum address like below, data of out of range will be ignored.
1. 132X132 memory base (GM=’101’)
(Parameter range: 0 XS[15:0] XE[15:0] 131(0083h):MV=”0”)
(Parameter range: 0 XS[15:0] XE[15:0] 131(0083h):MV=”1”)
2. 130X130 memory base (GM=’100’)
(Parameter range: 0 XS[15:0] XE[15:0] 129(0081h):MV=”0”)
(Parameter range: 0 XS[15:0] XE[15:0] 129(0081h):MV=”1”)
3. 128X160 memory base (GM=’011’)
(Parameter range: 0 XS[15:0] XE[15:0] 127(007Fh):MV=”0”)
(Parameter range: 0 XS[15:0] XE[15:0] 159(009Fh):MV=”1”)
4. 120X160 memory base (GM=’010’)
(Parameter range: 0 XS[15:0] XE[15:0] 119(0077h):MV=”0”)
(Parameter range: 0 XS[15:0] XE[15:0] 159(009Fh):MV=”1”)
5. 128X128 memory base (GM=’001’)
(Parameter range: 0 XS[15:0] XE[15:0] 127(007Fh):MV=”0”)
(Parameter range: 0 XS[15:0] XE[15:0] 127(007Fh):MV=”1”)
6. 132X162 memory base (GM=’000’)
(Parameter range: 0 XS[15:0] XE[15:0] 131(0083h):MV=”0”)