User Manual

1001 I C I C 0x5E Master
1010 I C I C 0x5F Master
1011 I C I C 0x60 Master
1100 I C I C 0x61 Master
1101 UART at 57600 UART N/A Master
1110 UART at 115200 UART N/A Master
1111 N/A Reserved N/A N/A
Bold text is the default setting for the Qwiic Motor Driver
Thermal Conduction Area
The Qwiic Motor Driver is designed to operate small robot drive motors without a
heatsink; we were able to run up to about 1.1A continuous current without going above
100°C. If you find that you need a heatsink, you can use our Theragrip Thermal Tape to
attach three Small Heat Sinks across the thermal conduction area on the back of the
board.
2 2
2 2
2 2
2 2
8/18