User Manual

I C Jumpers I C pull-up
enable
Opening these disables theI C pull-up resistors used
for I C communication. If multiple I C devices are
being used, these pull-ups should be disabled on all
but one device. If UART is being used, the pull-up
resistors should be disabled.
Address
Jumpers
Serial and
function
selection
The config bits are 4 bits that form a configuration
nybble. A closed jumper is a '1' and an open jumper is
a '0'. See config table for more information.
I C Pull-Up Jumpers
Address Bits
The configuration is set by encoding a number into the 4 config bits on the bottom of the
board. Close a jumper to indicate a 1, or leave it open to indicate a 0.
2 2 2
2 2
2
6/18