User Manual

collisions:0 txqueuelen:1000
RX bytes:20955 (20.4 KiB) TX bytes:9956 (9.7 KiB)
If it looks similar but the IP addresses aren't present, that network link hasn't been established.
In this example, we know our Ethernet is on IP 14.7.3.188 and our wireless on 32.8.0.142. These
can be entered into the PuTTY configuration window to begin the session. From here, it just
works like the serial link!
Configuring PuTTY
Configuring the Pi
This section goes over configuring the keyboard, wired, and wireless internet.
Configuring the Keyboard Layout
The Raspbian distribution comes defaulted to European hardware. With US keyboards, the "
(quotation mark) symbol is replaced by @ (commercial at) and our number sign # is replaced by
the European pound sign £. This can make it aggravating when trying to #define things. Invoke
the config tool with "sudo raspi-config," and take the following actions:
 Set the default locale for the system
o Select "Internationalisation Options"
o Select "Change Locale"
o Deselect en_GB.UTF-8 UTF-8
o Select en_US.UTF-8 UTF-8, (Ok)
o Set default to en_US.UTF-8, (Ok)
 Change the keyboard layout -- from the Internationalisation Options menu,