Data Sheet

SAM-M8Q - Data Sheet
UBX-16012619 - R04 Production Information Default messages
Page 22 of 25
8 Default messages
Interface
Settings
UART Output
9600 Baud, 8 bits, no parity bit, 1 stop bit
Configured to transmit both NMEA and UBX protocols, but only the following NMEA (and no UBX)
messages have been activated at start-up:
GGA, GLL, GSA, GSV, RMC, VTG, TXT
UART Input
9600 Baud, 8 bits, no parity bit, 1 stop bit, Autobauding disabled
Automatically accepts following protocols without need of explicit configuration:
UBX, NMEA, RTCM
The GNSS receiver supports interleaved UBX and NMEA messages.
DDC
Fully compatible with the I
2
C industry standard, available for communication with an external host CPU or
u-blox cellular modules, operated in slave mode only. Default messages activated.
NMEA and UBX are enabled as input messages, only NMEA as output messages.
Maximum bit rate 400 kb/s.
TIMEPULSE
(1 Hz Nav)
1 pulse per second, synchronized at rising edge, pulse length 100 ms
Table 9: Default messages
Refer to the u-blox 8 / u-blox M8 Receiver Description Including Protocol Specification [2] for information
about further settings.