Data Sheet

4D SYSTEMS uUSB-PA5
© 2015 4D SYSTEMS Page 3 of 7 www.4dsystems.com.au
microUSB - μUSB-PA5
1. Description
The microUSB Programming Adaptor is a USB to
TTL UART bridge converter which is simple, cost
effective, very small and easy to use.
There are 2 versions of the microUSB
Programming Adaptor, the uUSB-PA5 and the
uUSB-PA5-II.
They both use a mini-B type USB connector to
connect to your PC. The uUSB-PA5 is based on the
FTDI FT232RQ USB to Serial Bridge IC from FTDI
Chip, while the uUSB-PA5-II is based on the SiLabs
CP2104 USB to Serial Bridge IC from Silicon Labs.
From the perspective of programming 4D Systems
modules, both the uUSB-PA5 and uUSB-PA5-II
operate in the same way.
They provide the User with multi baud rate serial
data and access to additional signals such as flow
control in a convenient 10 pin 2.54mm (0.1”) pitch
Dual-In-Line package.
The main 5 pin interface is a standard 2.54mm
(0.1”) pitch female header, designed to connect
directly to a majority of the 4D Systems modules.
The uUSB-PA5 and uUSB-PA5-II are ideal for
prototype or production.
RX and TX signals are both 3.3V and 5V tolerant.
2. Module Compatibility
The uUSB-PA5 was designed in 2012. The uUSB-
PA5-II was designed in 2015 to replace the uUSB-
PA5.
While a large range of 4D Systems modules are
compatible with these programming adaptors,
some are not, for mechanical reasons.
The following is a small list is of known modules
that are not compatible with the uUSB-PA5/PA5-II.
uLCD-28PT (note, this is not the PTU)
uLCD-32PT (note, this is not the PTU)
Please use the 4D Programming cable instead, or
simply connect the 5 way cable that ships with
each module, between the uUSB-PA5/PA5-II and
the display module, which overcomes this
compatibility issue.
3. Features
USB 2.0 compliant Full Speed 12Mbps
maximum speed, Suspend supported.
Hardware or Xon/Xoff handshaking supported,
300bps to 3Mbps (uUSB-PA5), 300bps to 2Mbps
(uUSB-PA5-II)
UART supports 7 or 8 data bits, 1-2 Stop bits,
odd/even/mark/space and no parity (uUSB-PA5).
5, 6, 7, 8 data bits, 1, 1.5, 2 stop bits,
odd/even/mark/space and no parity (uUSB-PA5-II)
Power on reset circuit
Virtual COM port drivers allow operation with
existing COM port PC applications
Supports Windows 2000 and above, MAC (OSX-
8 and above) and Linux (2.4 kernel and above)
USB powered
-40 to +85 degrees Celsius temp range
Small size, 33.7mm x 17.3mm
Traffic/Operation LED indicates board status
Additional flow control and features available
for the user to solder, using standard 2.54mm
(0.1”) pitch through holes along each side of the
PCB.
RoHS Compliant