Datasheet

The Teensy is a breadboard-friendly development board with loads of features in a tiny

package. The Teensy LC (Low Cost) is a 32 bit microcontroller board that provides you

with an uncomplicated option for getting started with the Teensy line of products without

breaking the bank!

The Teensy LC comes pre-flashed with a bootloader so you can program it using the on-

board USB connection: No external programmer needed! You can program for the

Teensy in your favourite program editor using C or you can install the Teensyduino add-

on for the Arduino IDE and write Arduino sketches for Teensy!

The processor on the Teensy also has access to the USB and can emulate any kind of

USB device you need it to be, making it great for USB-MIDI and other HID projects. The

32 bit processor brings a few other features to the table as well, such as multiple

channels of Direct Memory Access and an I2S digital audio interface! There are also 2

separate interval timers! Also, the Teensy LC can provide system voltage of 3.3V or 5V

to other devices at up to 5-20mA.

All of this functionality is jammed into a 1.4 x 0.7 inch board with all headers on a 0.1"

grid so you can slap it on a breadboard and get to work! So, what sets the Teensy LC

apart from the Teensy 3.1? First off, this version has been streamlined to be as cost

effective as possible. Obviously, the LC doesn't share a lot of power that the 3.1

possesses but by no means does it make the LC a 'weak' board! The Teensy LC is

equipped with 8kB RAM, 62kB of flash memory, and 27 Digital I/O pins with 13 high res

Analog inputs.

PAGE 1
The Teensy is a breadboard-friendly development board with loads of features in a tiny package.
PAGE 2
Note: The Teensy LC does not come with a micro-B USB cable. Features:             32 bit ARM Cortex-M0+ 48 MHz CPU 62kB Flash Memory, 8kB RAM, 1/8(emu)kB EEPROM 13 High Resolution Analog Inputs 27 Digital I/O Pins (NOT 5V Tolerant) 10 PWM outputs 7 Timers for intervals/delays, separate from PWM 3 UARTs (serial ports) SPI, I2C, & I2S I2S (for high quality audio interface) 4 Lightweight DMA channels Touch Sensor Inputs 1.4 x 0.