Datasheet
DG600F Coin Acceptor Technical Manual Version 1.0 - 06.2010
Page 21 of 21-
9.3
9.39.3
9.3
Send No Signal After Deposit C
Send No Signal After Deposit CSend No Signal After Deposit C
Send No Signal After Deposit Coins
oinsoins
oins
Check if the machine charge amount setting is right or not, if coin value deposited falls
short of the charge amount, Coin Acceptor would not send any signal. For instance, coin
value deposited is 01, but machine charge amount is set as 02, then it would not send
signal when only one coin is deposited, but send signals after deposit two coins. Please
refer to 8.3 to check the machine charge amount settings.
Check output port selection is right or not, please firstly confirm that connection ports of
machine and coin acceptor are serial port or parallel port, and then check the selection
according to 8.7.
9.4
9.49.4
9.4
Send
Send Send
Send Error Signals A
Error Signals AError Signals A
Error Signals After
fter fter
fter Deposit Coins
Deposit CoinsDeposit Coins
Deposit Coins
When parallel port mode outputs error signal, please check if the settings of group
（C1~C6）the coin belongs to are correct.
When parallel port mode outputs error signal, please refer to 6.1 to check SW1 (serial
port electric level option) is on right position or not.
Please refer to 6.3 to check SW3 (serial port electric level option) is on right position or
not.
Please refer to 8.4 to check signal pulse-width and transmit baud rate is set right or not.
9.5
9.5 9.5
9.5 Coins
Coins Coins
Coins A
AA
Are
re re
re N
NN
Not
ot ot
ot E
EE
Easy
asy asy
asy T
TT
To
o o
o B
BB
Be
e e
e I
II
Identified
dentifieddentified
dentified,
, ,
, C
CC
Coins
oins oins
oins Are
AreAre
Are
R
RR
Retur
eturetur
eturn
nn
ned
eded
ed
F
FF
Frequently
requentlyrequently
requently
Since coins issued year, outline, used duratin is different, coin parameters will be little
differ from data stored in Coin Acceptor, please dial switch SW2 to ON position to loose
coin identification security
Plesae refer to 7.5, add new coin parameters.