Datasheet
DG600F Coin Acceptor Technical Manual Version 1.0 - 06.2010
Page 18 of 21-
8. Coin Acceptor Parameters Setting
8.1 Acess To Coin Acceptor Parameters Setting
8.1 Acess To Coin Acceptor Parameters Setting8.1 Acess To Coin Acceptor Parameters Setting
8.1 Acess To Coin Acceptor Parameters Setting
Keep pressing button B buton till
AP is displayed, it enters into setting mode.
LED displays AP , press button A to select working parameters.
AP A1 A2 A3 A4
8.2
8.28.2
8.2
Recover Coin Acceptor Parameters To The Defaulted Value
Recover Coin Acceptor Parameters To The Defaulted ValueRecover Coin Acceptor Parameters To The Defaulted Value
Recover Coin Acceptor Parameters To The Defaulted Value
Keep pressing B button when it displays AP , and release after “CC” is displayed, then all
parameters is recover to the defaulted value.
Defaulted value:
A1machine charge amount：01
A2 serial output signal pulse-width/ RS232 transmit baud rate：02 (45ms / 4800bps)
A3 faulty alarm option ：01（rings only one time）
A4 serial port RS232 signal length: 01（one byte）
A5serial port output：01
8.3
8.3 8.3
8.3 Machine
Machine Machine
Machine C
CC
Charge
harge harge
harge Amount
AmountAmount
Amount
S
SS
Setting
ettingetting
etting
A1
A1A1
A1
When it displays A1, press button B to display existing charge credit stored in machine.
Press button B to adjust from 01 to A0(A0=100).
01 02 … 98 99 A0
Press button B to select the charge amount needed, press button A to next group working
parameters A2.
Machine charging instructions:
E.g.: Set machine charge credit as 01, then serial port sends out one signal once when it
receives one coin with credit 01, and sends five signals once when it receives one coin with
credit 05.
E.g.: Set machine charge credit as 05, then serial port sends out one signal once when it
receives five coins with credit 01, and sends two signals once when it receives one coin with
credit 10.
E.g.: Set machine charge credit as 02, then serial port sent two signals once when it received
one coin with credit 05（05/02=02）, and there is remaining a coin credit, it will be cleaned up
if there is no new coin coming within 60 seconds.
NOTE：
：：
：Machine charge credit setting is not suitable for parallel port output mode.
8.4
8.48.4
8.4 Serial Output Signal Pulse-width/ RS232 Transmit Baud Rate Setting A2
A2A2
A2
When it displays A2, press button B to display existing parameters stored in machine.
01 (25ms/9600bps) 02 (45ms/4800bps)
04 (100ms/1200bps) 03 (65ms/2400bps)
Press button B to adjust the needed parameter, and then press button A to next group of Coin
Acceptor parameters A3.