Datasheet

DG600F Coin Acceptor Technical Manual Version 1.0 - 06.2010
Page 14 of 21-
6.3.2.1 Select mode 1-N.O.， In serial port output mode. (SW1 is on "OFF" position)
Note: Please select this mode when coin acceptor is connecting to machine's single
port.
◎RS232 output oscillogram
S：Start bit
B0 to B7：8 data bits
C：Even check
STOP：Stop bit
It can set the transmit rate（1200bps/2400bps/4800bps/9600bps）in coin acceptor
parameter A2.
6.3.2.2 Select mode 2-N.C.， In serial port output mode. (SW1 is on "ON" position)
Note: Please select this mode when coin acceptor is connecting to PC's RS232 port.
◎RS232 output oscillogram
S：Start bit
B0 to B7：8 data bits
C：Even check
STOP：Stop bits
It can set the transmit rate（1200bps/2400bps/4800bps/9600bps）in coin acceptor
parameter A2.
6.4
6.4 6.4
6.4 Inhibit
InhibitInhibit
Inhibiting
inging
ing Port
Port Port
Port Output Level
Output Level Output Level
Output Level
6.4.1 Forbidden Mode 1--Low Level forbid accepting coins
When SW4 is on “OFF” position,
If Inhibiting port is disconnected or connected to a high level（>+3V）, coin acceptor will
accept all coins.
If Inhibiting port is connected to a low level（<+1V），coin acceptor will refuse all coins.