Data Sheet

MPU-9250 Product Specification
Document Number: PS-MPU-9250A-01
Revision: 1.0
Release Date: 01/17/2014
3.4 Electrical Specifications
3.4.1 D.C. Electrical Characteristics
Typical Operating Circuit of section 4.2
, VDD = 2.5V, VDDIO = 2.5V, T
A
=25°C, unless otherwise noted.
PARAM ETER
CONDITIONS
MIN
TYP
MAX
Units
Note s
SUPPLY VOLTAGES
VDD
2.4
2.5
3.6
V
VDDIO 1.71 1.8 VDD V
SUPPLY CURRENTS
Normal Mode 9-axis (no DMP), 1 kHz gyro ODR, 4 kHz
accel ODR, 8 Hz mag. repetition rate
3.7 mA
6-axis (accel + gyro, no DMP), 1 kHz gyro
ODR, 4 kHz ac cel ODR
3.4 mA
3-axis Gyroscope only (no DMP), 1 kHz ODR 3.2 mA
6-axis (accel + magnetometer, no DMP), 4
kHz accel ODR, mag. repetition rate = 8 Hz
730 µA
3-Axis Accelerometer, 4kHz ODR (no DMP) 450 µA
3-axis Magnetometer only (no DMP), 8 Hz
repetition rate
280 µA
Accelerometer Low Pow er Mode
(DMP, Gyroscope, Magnetometer
disabled)
0.98 Hz update rate 8.4 µA 1
31.25 Hz update rate 19.8 µA 1
Full Chip Idle Mode Supply Current
8 µA
TEMPERATURE RANGE
Specified Temperature Range
Performance parameters are not applicable
beyond Specified Temperature Range
-40 +85 °C
Table 3 D.C. Electrical Characteristics
Notes:
1. Accelerometer Low Power Mode supports the following output data rates (ODRs): 0.24, 0.49, 0.98,
1.95, 3.91, 7.81, 15.63, 31.25, 62.50, 125, 250, 500Hz. Supply current for any update rate can be
calculated as:
Supply Current in µA = Sleep Current + Update Rate * 0.376
Page 11 of 42