User Manual

9
BILL OF MATERIALS
ITEM DESCRIPTION QTY
7 Cable Ties 5
6 Hex Nuts 4
5 Pulleys 5
4 Eye Bolts 2
3 Cable Clamps 2
2 Tagline Cable 1
1 Trolley Stops 2
Tagline Assembly
6
4
3
1
2
5
7
5' - 0"
5' - 0"
F
ROM SUPPLY
(CONDUCTOR NOT SUPPLIED)
TO EQUIPMENT
Wheel Brake Assembly Installation
For 6” and 8” diameter casters on SPANCO “A” & “E” Series Gantries
To set brake while assembling the caster:
1. Inspect the brake mechanism to ensure it is in working order.
2. Make sure the brake pedal is in the “off” position (pedal is in the up position).
3. Position the brake brackets over the outside of the fork legs. Line the bolt holes over each fork's bolt holes.
4. Insert the wheel between the fork legs and place the axle through the brake/fork holes and the wheel hub.
5. Thread the nut on the axle and tighten.
NOTE: NEVER CHANGE CASTERS WITH A LOAD ON GANTRY!
OPTIONAL ACCESSORIES
PEDAL
BRAKE