Install Manual

9SPAN Drive Installation Manual Preparing to install |
Dimensions, clearances, & access
The maximum distance SPAN Drive can be installed from
the SPAN Panel is 328 feet (100 meters).
Pick a location where the 20-foot charging cable will reach
the car’s charging port while still providing slack.
The minimum installation height must be at least 18”,
measured from the bottom of the charger.
SPAN recommends an installation height of at least 40”.
SPAN Drive is designed for hardwire installations. The wiring
may use either the rear or bottom access ports. The power
supply wiring and conduit (if used) will need to be placed
on the left side of the charger.
CAUTION: Follow all local codes and standards when planning for and installing SPAN Drive.
< 328’
18”
Minimum
40”
Recommended
< 20’
NOTE: Ensure that the charging cable is positioned in such a way so that it will not be stepped on, tripped
over, or subjected to damage or stress. Do not close a garage door on the charging cable. There should
always be slack in the charging cable so as not to apply tension to the cable or the cable connections.
NOTE: SPAN Drive includes integrated GFCI protection – do not install a GFCI circuit breaker or a
NEMA 14-50 outlet to power SPAN Drive. Two GFCIs on the same circuit can cause nuisance tripping.