Install Manual

7SPAN Drive Installation Manual Preparing to install |
2. Installation requirements
You will also need the following equipment and tools
that are not included in the packaging:
Required equipment
• Copper conductors rated to a minimum of 90°C,
such as THHN, THWN, NM-B, MC.
• Cable for communication between SPAN Drive and
the SPAN Panel (Minimum 300 V rated, shielded,
twisted-pair, 24–16 AWG). RS485-G optional, but
recommended to connect Drain wire to Drive and
Panel RS485-G terminals for best signal integrity.
• Conduit, conduit ttings, bushings that are suited
to the installation
• Smartphone or tablet with SPAN Installer App for
commissioning
• Personal Protective Equipment (PPE) should be
worn by all persons at the installation site and
properly rated for residential applications.
Required tools
• #2 Phillips screwdriver or bit
• Electric drill
• Small at head screwdriver (if changing the current
selector switch)
• Standard installation tools: wire cutters/strippers,
multimeter, stud nder, measuring tape, pencil,
tape, step bits (optional)