Install Manual

12SPAN Drive Installation Manual Installation |
Preparing conduit ttings & bushings
The default conduit size is ¾” (21mm).
1” (27mm) conduit is acceptable if needed.
Based on ttings and conduit size, prepare SPAN Drive:
For bottom entry, manually remove the conduit plug.
For rear entry, drill with a step bit to prepare
SPAN Drive for ttings.
The knockout size is ¾” trade size and can also
accommodate 1” trade size.
3. Mounting SPAN Drive
Depending on the material of the mounting wall,
use the appropriate hardware and drill pilot holes as
needed. The wall anchors provided in packaging work
for brick, block, and concrete and require a ¼” drill bit
for pilot holes. SPAN Drive weighs a total of 16 lbs.
Drive the topmost lag screw (max #12 screw) into the
wall rst. Leave approximately 1/2” of the end of the
screw exposed to hang the charger. Hang SPAN Drive
on the lag screw using the notch on the back of the
charger. For rear entry installation, draw the power
supply wiring through the hole in the wall and through
the rear port before securing the charger.
Drive the remaining two lag screws into the two
bottom mounting holes to secure the charger.
Be careful not to damage the electrical wires.
Distance from wall
1/2”