Install Manual

10SPAN Drive Installation Manual Installation |
Installation
1. Determine wiring entry
Bottom or rear entry
SPAN Drive allows power supply wiring and conduit
entry either through the bottom or rear section of
the charger. Before proceeding with the hardwire
installation, determine the most appropriate entry
location based on the placement of wiring or conduit.
Be sure to note that the bottom and rear entry
locations are both on the left side of the charger.
Bottom entry Rear entry
NOTE: When bringing conduit from the right side of the enclosure for a bottom entry installa-
tion, make sure there is appropriate clearance for the charging cable.
NOTE: For rear entry installation, adhere the optional
gasket for sealing around the knockout.
NOTE: If mounting on an exterior wall and bringing power
through the rear knockout, apply sealant around the rear
knockout to prevent water ingress.