Install Manual
Table Of Contents
- CONTENTS
- ABOUT YOUR span panel
- Preparing to Install
- Installation
- Troubleshooting & SERVICING
- APPENDIX A: circuit breaker Compatibility
- The Span Panel is compatible with the following Homeline circuit breakers from Square D:
- The Span Panel is compatible with the following circuit breakers from Eaton:
- The Span Panel is compatible with the following circuit breakers from Siemens:
- The Span Panel is compatible with the following MP circuit breakers from Murray:
- APPENDIX B: Surge protective device compatability
Span 1-00800-xx Installation Manual (rev. 2022-01-28) 18
8. Final Inspection and Closing the Unit
● Confirm that all connections are correct, properly grounded, and secure.
● Replace the deadfront and securing using the flathead screw.
● Install the door by sliding down onto the hinges.
● Only after fully replacing the deadfront assembly, restore power.
● Lock the panel closed with the hasp at the bottom of the panel door using a lock provided by the homeowner.
WARNING: Risk of electric shock. Do not modify the deadfront other than to configure the door hinges or to remove or
replace breaker filler plates, as needed.
9. Commissioning
The Panel must be configured with the Span Installer App prior to use.
Download the Span Installer App from www.span.io/span-apps
Follow the on-screen instructions. When prompted to connect to the panel, refer to the panel Serial Number located on the product
label inside of the door.
NOTE: When Span’s relays open/close they will sound like a digital camera taking a photo. When Span transitions on- or
off-grid, several relays may open/close at once which sounds like a digital camera taking multiple photos. This is normal.
Span Installer App home screen