Install Manual
Table Of Contents
- CONTENTS
- ABOUT YOUR span panel
- Preparing to Install
- Installation
- Troubleshooting & SERVICING
- APPENDIX A: circuit breaker Compatibility
- The Span Panel is compatible with the following Homeline circuit breakers from Square D:
- The Span Panel is compatible with the following circuit breakers from Eaton:
- The Span Panel is compatible with the following circuit breakers from Siemens:
- The Span Panel is compatible with the following MP circuit breakers from Murray:
- APPENDIX B: Surge protective device compatability
Span 1-00800-xx Installation Manual (rev. 2022-01-28) 17
7. Installing the Flush Mount Trim Kit
The Flush Mount Trim Kit (PN: 1-01046) is used for indoor installations to easily cover square holes cut into the wall during installation.
The overall dimensions when mounted are 1123 x 405 mm (44.2 x 15.9 in).
• Place the two (2) metal Trim Mounting Brackets directly against the Span Panel’s top and bottom faces, using the triangular
decals to center.
• Affix the upper and lower Trim Mounting Brackets to the wall or stud using four (4) mounting screws.
• Snap the Trim Piece in place, ensuring all four mounting sockets are fully engaged.
Installing Trim Mounting Brackets
Snapping Trim Piece in Place