Operation Manual

Page 17
Space Scooter
®
F.A.Q. (frequently asked questions)
The Space Scooter
®
does not unfold.
Be sure you have read the instruction manual carefully and understand how the Space
Scooter® works.
a) If you are sure you are doing everything right, ensure the brake at the rear wheel is
not pressed against the wheel. If this is the case, you can use a wrench size 8 to
unloosen the nut and give the cable/break some more space. When you’re done,
fasten the nut again.
b) If the problem still exists, please contact the helpdesk by e-mail:
[e-mail].
The grip of the tray plank diminishes.
Please contact the store where you bought your Space Scooter®. Or when not available
contact us by e-mail ([e-mail]) with a clear description of the problem.
HOW TO: FOR REPLACING THE GRIP STICKER.
a) Remove the existing sticker. You can easily peel off the sticker with your nail. Gently
pull off the sticker.
b) Make sure the tray shelf is clean. (defatted)
c) Peel off the new sticker from its back-side. Make sure to start at the square end and
only peel the first few centimeters. (This is applied at the front side of the Space
Scooter®)
d) Place the square end of the sticker straight onto the tray plank. Pull the sticker's
back-side off bit by bit whilst rubbing the sticker onto the tray. Make sure to create
no air pockets while applying.
The chain skips or runs next to the gears(flywheel).
Please contact the store where you bought your Space Scooter®. Or when not available
contact the helpdesk by e-mail ([e-mail]) with a clear description of the
problem. The spring that keeps the chain in place is probably stretched.
HOW TO: REPLACE THE CHAINSPRING.
a) Retrieve the necklace of the gears (how to do this you will find in the workshop
manual available on www.spacescooter.eu)
b) Loosen the inbus that holds the spring on the front.
c) Loosen the inbus that hold the other side of the spring.
d) Insert the new spring in reverse order.