Specifications

Opening width
(Selected from table)
Openingwidth
(Selected from table)
Openingwidth
(Selected from table)
Openingheight
2260mm /89”
Opening height
2260mm /89”
The use of end fillets is recommended to allow
the doorsto slide flush where an existing skirting
board is fitted. Remove a section of the skirting
and fit an end fillet.
To reduce your opening width by up to 127mm /
5” on each side use Spacer Blocks together
with the end fillet and appropriate infill. Detailed
instructions are provided with each Spacer
Block pack.
To reduceyour opening by more than 457mm /
18” on each side you can construct an ‘L’
section using an end panel and end fillet.
Jointed together with Fixing Blocks and scribed
to fit thewall and skirting.
To reduce your opening width from between
127 - 457mm /5-18” on each side you can
use Opening Reducers fixed to the side wall.
Detailed instructions are provided with each
Opening Reducer.
To stop the doors short of an obstructionsuchas
awindow or door, construct areturn endpanel
from melamine faced chipboard. Cuttofit the
exact ceiling height and scribe back edgetofit
rear wall and skirting.
Fix return end in position with Fixing Blocks
equally spaced.
If in doubt about
the strengthof the fixings,
usethe methods
below. Irregularities of plus
or minus
12mm are
automaticallycompensated
by thetop guide.
IfThe Top & Bottom Tracksets can be fitted directly
to your ceiling and floor using appropriate fixing,
which you can buy from any good DIY center.
your ceilingheightis between 2272 - 2399mm
/89½”- 94 ½” use Spacer Block to reduce it to
2260mm/89”. Detailed instructions are
provided with each Spacer Block pack.
For ceilings between 2399–2729mm /94½”–
107½” use Opening Reducers.Detailedfixing
instructions are provided with each Reducerpack.
min. of
593mm
Min. of
25mm (1”)
Min.of
102mm (4”)
Side
Wall
Opening
Reducer
Floor Track
Back
Wall
Fixing
Blocks
Normally amin.
of 593mm
if used
as awardrobe.
Openingheight
2260mm (89”)
Fascia
Fas
Top track
Fascia
Fascia
Top track
Ceiling
OHR
OHR
Ceiling
Ceiling
cia
Opening height
2260mm (89”)
End fillet
Infill
thickness
Any number
of Spacer
Blocks
maybe
interlocked
Scribe end
panelto wall
and around
skirting
Fixing
Blocks
Floor Track
A For tracks running at
right angles to the joists,
make holes in the track
in line with the joists to
screw into the joists.
B For tracks running in
line with the joists, make
holes at regular intervals
in the track and screw
into the joists.
CFor tracks between
joists;fixnoggins
between thejoistsand
screw intothe noggins.
DFor lathe and plaster;
fix cantilever battens
directly to theceiling and
screw intothese.
EFor tracks fixing to a
solid ceiling; drill and
screwdirectly to the
ceiling.
FFix floor trackdirectly
on topofthe carpet or
floor covering usingthe
short screws provided or
double sided tape.
HOW TO CONSTRUCT YOUR OPENING WIDTH HOW TO CONSTRUCT YOUR OPENING HEIGHT
Fitting to the wall
Fitting Wall to
side fillet
Fitting Wall to
end panel
Fitting Floor to Ceiling
Height 2260mm
Fitting Floor to Ceiling
Height Over 2260mm
A B C D E
*Please Note: Illustrations are not to scale. Products may vary slightly to what is shown, but basic fitting instructions will apply to all.
Fitting Standard Door Instructions
UK_STD_HD06.14
www.hdhc.com
STANDARD SIZED SLIDING DOORS