User's Manual

Ultraview Digital Telemetry
4-8 071-0774-00 Rev. A
Refer to the Module Configuration Manager chapter in the UCN Operations
Manual for NIBP parameter tables that list available user settings and factory
defaults for this parameter.
Displaying New or Previous Readings
The current (or latest) NIBP reading taken may be displayed when the NIBP
parameter is enabled and the 90217 ABP monitor is correctly setup. The current
reading is displayed just below the isoelectric line showing systolic, diastolic, and
mean values with the time of the reading. The displayed values are replaced by
??? when no valid values have been acquired from the 90217.
The previous NIBP readings may be displayed using the Tabular Trend or
Graphic Trend monitor functions. The parameter trend information is collected
from the module on a minute-by-minute basis and stored in system memory for
retrieval. The collected NIBP trend readings may be displayed in the same
manner as any other monitored parameter. Refer to the Trends chapter in the
UCN Operations Manual for details.
!
• The following ECG alarm messages take priority over other
ECG and NIBP alarm messages for display. Other ECG and
NIBP alarm messages can be adjusted in priority by using the
Module Configuration Manager.
LEADS OFF
NOISY SIGNAL
ECG ALARMS SUSPENDED
To display the current reading:
1 Touch ECG
2 Touch CHANNEL FORMAT
3 Select NIBP ON
To display previous readings in
tabular format (1030/1050):
1 Touch SPECIAL FUNCTIONS.
2 Select LOCAL TRENDS or
REMOTE TRENDS.
3 Select subnet and bed number.
4 Touch TABULAR TRENDS.
5 Select TIME INTERVAL or
ARROWS to adjust the time
interval and period.
(UCW and 1700):
1 Touch SPECIAL FUNCTIONS.
2 Touch TABULAR TRENDS.
3 Select LOCAL BED or
REMOTE BED.
4 Select bed number.
5 Select TIME INTERVAL or
ARROWS to adjust the time
interval and period.
To display previous readings in
graphic format (1030/1050):
1 Touch SPECIAL FUNCTIONS.
2 Touch LOCAL TRENDS or
REMOTE TRENDS.
3 Select bed number.
4 Touch GRAPHIC TRENDS.
5 Touch TOP GRAPH of
BOTTOM GRAPH.
6 Touch desired parameter to
graph.
(UCW and 1700):
1 Touch SPECIAL FUNCTIONS.
2 Touch GRAPHIC TRENDS.
3 Select LOCAL BED or
REMOTE BED.
4 Select bed number.
5 Touch desired parameter to
graph.