User's Manual

BIS
23-19
Care and Maintenance
BIS Module and Host Monitor Cleaning
To clean monitor screens and covers, modules, processors, and printers use a
cloth or swab that has been slightly dampened in a solution of warm water and a
mild detergent. Avoid solvents that may damage the product cases. Follow your
hospital protocol.
Digital Signal Converter Cleaning
Clean all visible blood, liquids, and soil as soon as possible from the Digital Signal
Converter (DSC), cabling, and connectors. Use a lint-free, absorbent towel that
has been moistened (damp, but not dripping) with a solution of mild detergent and
lukewarm, clean water. Using light pressure, thoroughly clean all surfaces. Dilute
and handle detergents and disinfectants according to their instructions. Dispose of
the towels properly.
Before cleaning, wipe thoroughly. Apply an approved disinfectant for the DSC with
a germicidal, disposable wipe, such as the SANI-CLOTH. Active ingredients in the
approved wipe are: n-Alkyl dimethyl benzyl ammonium choride (0.1%), and n-
Alkyl dimethyl ethylbenzyl ammonium chloride (0.1%). Be sure the disinfectant is
not dripping from the wipe. Using light pressure, wipe the surface of the DSC, its
cabling, and connectors as indicated by manufacturer’s instructions. Dispose of
the wipes properly.
BIS Sensor Disposal
The BIS Sensor is a patient-connected, single-use sensor that must be disposed
of after each use. Dispose of the sensor per your applicable hospital practice.
CAUTION:
• Using cleaning agents other than those listed may cause
degradation to the product’s plastic enclosure and labels.
Refer to Cleaning and Sterilization on page 32-1 for
questions or concerns regarding cleaning.
CAUTION:
• When cleaning the connectors (or other small features of
the DSC), do not let dirt, moisture, or lint get trapped in the
cracks or cavities of the receptacle or pin ends.
• Do not autoclave any of the components of the BIS
monitoring system. Autoclaving will seriously damage the
components.