User's Manual

Ultraview Care Network
23-14
SETUP Key
This menu enables you to set the display parameters to be used during the
procedure. Refer to the following sections for descriptions of each key:
• DISPLAY FORMAT Key on page 23-14
• PLOT SCALES Key on page 23-15
• TIME SCALES Key on page 23-15
• SIZE Key on page 23-15
• SWEEP SPEED Key on page 23-15
• ADVANCED SETUP Key on page 23-15
DISPLAY FORMAT Key
From this menu, you can set the type of display you want to use.
• Touch 1 ZONE to display the single waveform zone format (Figure 23-12).
• Touch 3 ZONE to display the full bedside view format (Figure 23-13).
• Touching AUTO ZONE displays either format as follows:
- 3-zone format if the BIS parameter key is touched.
- 1-zone format if the BIS parameter key is not touched.
Figure 23-12: One-zone display
Figure 23-13: Three-zone display