User's Manual

Ultraview Care Network
21-10
Adjusting the Waveform Size
The capnography waveform can appear on your monitor in three scale sizes: 0 to
40 mmHg (0 to 5.3 kPa), 0 to 60 mmHg (0 to 8.0 kPa), or 0 to 80 mmHg
(0 to 10.7 kPa).
Turning the Waveform Display On/Off
You can turn the capnography waveform ON or OFF.
Selecting a Unit of Measure
You can monitor capnography values as a percentage or with the monitor’s
selected units of measurement for pressures (mmHg or kPa).
Selecting a Sweep Speed
You can view capnography waveforms at any of the following sweep speeds: 25,
12.5, 6.25, 3.12, or 1.56 mm/second.
Respiration Tone
You can turn the respiration cycle tone ON or OFF, and adjust the volume of the
respiration cycle tone that sounds at the peak of the respiration cycle.
To adjust the waveform scale
size:
1 Touch GAS.
2 Touch SETUP.
3 Touch SIZE.
4 Select the desired scale.
To turn the waveform display ON
or OFF:
1 Touch GAS.
2 Touch SETUP.
3 Touch SIZE.
4 Select WAVEFORM ON or
OFF.
To select a measurement unit:
1 Touch GAS.
2 Touch SETUP.
3 Select PERCENT or mmHg
(kPa).
To select a sweep speed:
1 Touch GAS.
2 Touch SETUP.
3 Touch SWEEP SPEED.
4 Select desired sweep speed.
To turn tone OFF:
1 Touch GAS.
2 Touch SETUP.
3 Touch RESP TONE.
4 Select RESP TONE OFF.
To adjust the tone volume:
1 Touch GAS.
2 Touch SETUP.
3 Touch RESP TONE.
4 Select RESP TONE ON.
5 Use arrow keys to adjust the
volume.