User's Manual

Remote Display
28-3
Resetting Default Values
Touching FACTORY DEFAULTS resets the secondary display to its factory
values. Touch STORE to make these changes permanent.
Options that can be reset include:
• Relative priorities and colors to factory default configuration of primary
• Blanks caused by deleting a parameter while in Lock Mode
Touching this key does not insert any new parameters added while the secondary
display was in Lock Mode.
Tracking or Locking Displays
In addition to parameter color and priority, you may configure other attributes of
the secondary display to be different from the primary monitor. To make additional
adjustments to each display separately, select LOCK after you configure the
secondary display. This allows the secondary display to remain largely
unchanged when you adjust the primary display. If you need the secondary
display to duplicate changes to the primary, set the secondary display to TRACK.
Refer to the Table 1 (where X = yes) for the effect of Track and Lock on each
display characteristic.
To make additional changes to the secondary screen after you select LOCK,
return to the Secondary Configuration menu and touch TRACK.
Table 1: Remote Display Track and Lock Chart
Always
independent
of primary
Track
mode
copies
primary
Lock
mode
copies
primary
Lock mode
does not
copy primary
Colors/priorities X
Waveform size XX
Sweep speed XX
Full scales ON/OFF XX
Full scales 4/6 zones X
# of minor graticules X
Screen/waveform
attributes
XX
Addition of parameter
on primary
XX
Deletion of parameter
on primary
XX
Pressure/ECG key
labels
XX
Zone size of certain
displayed parameters
XX
To set factory default values of
secondary display:
1 Touch MONITOR SETUP.
2 Touch SECONDARY CONFIG.
3 Touch PARAMETER CONFIG.
4 Touch FACTORY DEFAULTS.
5 Touch STORE.
To lock the secondary display:
1 Adjust parameter attributes on
primary to reflect how you want
the secondary to appear.
2 Touch MONITOR SETUP.
3 Touch SECONDARY
CONFIGURATION.
4 Touch PARAMETER
CONFIGURATION.
5 Touch LOCK.