User's Manual

Ultraview Care Network
28-2
parameters and the ALL key displays all possible parameters. Each parameter is
assigned a display priority, with the highest priority appearing at the top of the
screen.
Blank parameter keys allow you to force a space above, between, or below other
parameters. Blanks can be inserted into any priority template by selecting the
blank and putting it into the desired location. This causes a blank zone to be
inserted into the corresponding display area and all active parameters with a
lower priority to be pushed down.
The STORE key stores the current local priority and color settings into non-volatile
memory.
The RESTORE key restores the last stored local priorities and color settings from
memory.
The FACTORY DEFAULTS key restores the factory default priority and color
settings.
Copying Stored Values of the Primary
Monitor
Touch COPY PRIMARY PRIO/COLOR to duplicate the primary display’s stored
settings for priorities and colors on the secondary display. Touch STORE to put
these changes into effect.
You can use the Copy Primary Prio/Color function to remove blank zones
resulting from parameters that were deleted while the secondary display was in
Lock mode.
Restoring a Stored Value
Touch RESTORE to reset the secondary display’s configuration screen to its last
stored changes. Restoring the screen also stops the Copy Primary function (if
STORE has not yet been touched).
Copying Primary Attributes to the
Secondary
Touch COPY PRIMARY PARAM ATTR to copy the primary's current parameter
attributes or settings to the secondary display. Parameter colors and priorities are
not copied.
Use this key to:
• Remove any blank zones caused by deleting a parameter while the
secondary was locked.
• Insert any new parameters added while the secondary was locked.
• Change sizes, sweep speeds, full scales ON/OFF, etc., to match the primary
monitor’s configuration.
To copy the stored values of the
primary:
1 Touch MONITOR SETUP.
2 Touch SECONDARY CONFIG.
3 Touch PARAMETER CONFIG.
4 Touch COPY PRIMARY
PRIO/COLOR.
5 Touch STORE.
To restore the last stored
configuration:
1 Touch MONITOR SETUP.
2 Touch SECONDARY CONFIG.
3 Touch PARAMETER CONFIG.
4 Touch RESTORE.
To copy the primary monitors
configuration:
1 Touch MONITOR SETUP.
2 Touch SECONDARY CONFIG.
3 Touch PARAMETER CONFIG.
4 Touch COPY PRIMARY
PARAM ATTR.