User's Manual

Ultraview Care Network
5-14
Battery Status Messages
The Ultraview 1030/1050 provides you with several battery condition status
messages.
Battery Charged — A Solid Green LED
A solid green LED indicates the battery, or batteries, installed into the monitor are
fully charged and are ready to be used.
It functions with the monitor powered ON and with the monitor powered OFF.
Battery Charging — A Flashing Green LED
A flashing green LED indicates the battery, or batteries, installed in the monitor
are not fully charged and are not ready to be used. The flashing is different than
the battery fault detection flash.
The flashing LED turns on and off in a constant pattern, with no delays. It
functions with the monitor powered ON and with the monitor powered OFF.
Battery Fault Detected — An Intermittent Flashing Green LED
An intermittent flashing green LED indicates that either battery A or battery B is
faulty. Faulty batteries are determined to be batteries which do not hold a charge
or batteries which attempt to charge too long. The flashing is different than the
battery charging flash.
The intermittent signal will display a solid green LED for one second and then
display a flashing LED for one second in a repeating pattern. An error log
message is also added to the CMOS error log for review by your system
administrator.
To determine whether one battery, or both, is faulty, power the monitor ON using
the front panel switch and observe the display message. The message will display
along the bottom of the monitor indicating whether one, or both, of the batteries
are faulty. Replace the faulty battery with a fully charged battery.
Battery Gauge
The battery gauge is always present in the lower-right corner of the display when
the monitor is powered ON and not plugged into AC power. This gauge indicates
the approximate battery capacity. For example, the gauge will display:
• a fully charged battery
• 3/4 battery charge remaining
• 1/2 battery charge remaining
• 1/4 battery charge remaining
• minimum battery charge remaining
!
• If a battery is not installed, a solid green LED will also display.