User's Manual

Bedside/Transport Monitors

5-11

Once the data is completely transferred, the monitor sounds a tone and displays

the message DATA TRANSFER COMPLETED below the UPDATE TRANSFER

and CANCEL TRANSFER keys. The module is now ready to be removed from

that monitor.

Figure 5-6: Data Transfer Completed display

If you do not transfer the module to the receiving monitor immediately, the source

monitor will be storing new data, but the module’s transfer data is not

automatically updated.

After 2-minutes, a tone will sound once each minute to remind you to update the

module with the newly acquired data and the monitor will display the message

DATA TRANSFER COMPLETED.

The message DATA IS XX MINUTES OLD displays the amount of time that has

elapsed since you last transferred the data. The monitor updates this message

each minute.

Updating the Data Transfer

If time has elapsed between data transfer into the module and module removal,

you may wish to update the transferred data before you remove the module. To

update this data, touch UPDATE TRANSFER.

While the data is being updated, the monitor re-displays the message

TRANSFERRING PATIENT DATA INTO MODULE.

Canceling the Data Transfer Before Module Removal

Touch the CANCEL TRANSFER key to clear all data transfer messages and keys

from the ECG display zone and purge previously transferred data from the

module. The monitor will then reactivate the TRANSFER DATA key in the ECG

Setup menu.

• Parameter information acquired between the time you transfer

data and the time you remove the module is lost. The monitor

indicates this lost information as a gap in the trends of the

parameters involved when you retrieve the data.

• To provide seamless trend information, remove the module and

insert it into the receiving monitor within 30- to 45-seconds after

you transfer the data. If there is a delay in completing the data

shuttle, update the transfer data just before you remove the

module.

• If the module has been out of the monitor for 10 or more

minutes, all data will be lost.

CANCEL TRANSFER

UPDATE TRANSFER

DATA TRANSFER COMPLETED

To update transfer data, touch

UPDATE TRANSFER.

To cancel data transfer, touch

CANCEL TRANSFER.