User's Manual

Bedside/Transport Monitors
5-5
Bedside and Transport Monitor Features
Adjusting Screen Brightness and Contrast
Using the Monitor Setup menu you may increase or decrease the monitors’
screen contrast and brightness.
Ultraview 1030/1050 monitors contain a SCREEN BRIGHTNESS key for monitors
operating on AC power enabling you to set the screen to NORMAL or DIM.
Setting the screen to DIM also enables the power saving features such as shutting
off the LEDs and disabling the mouse and keyboard. The screen will also dim
approximately 30-seconds after the last time a key is touched or after the final
alarm ends. Ultraview 1030/1050 monitors operating on DC (battery) power
contain an ENERGY SAVING MODE ON/OFF key that enables and disables the
power saving features.
Setting QRS Tones
Your monitor can be configured to sound a tone whenever an R-wave (QRS tone)
or SpO
2
pulse (SpO
2
tone) is detected. The pitch of the QRS tone can be
modulated with the current SpO
2
value. Refer to Adjusting Tones on page 8-16
and Adjusting Tone Volume on page 14-8 for more information.
Your monitor has two options for how the QRS or SpO
2
tone sounds if it has been
enabled via either parameter’s TONE ON/OFF key. Your monitor can be
configured to always sound this tone (default setting) or to only sound this tone
when an alarm is occurring.
On UCW and Ultraview 1700 monitors, this selection is available to any user with
the Clinical level of “privileged access.” On Ultraview 1030, 1050, 1500, and 1600
monitors, this selection is only available to your system administrator.
Using Scaled Displays
Bedside monitors display up to four scaled pressures simultaneously.
Monitors optionally display minor graticule lines that may be adjusted. Minor
graticules are small dashed line segments that appear between the full scale
graticule lines.
To adjust screen clarity:
1 Touch MONITOR SETUP.
2 Touch MONITOR CONFIG.
3a Touch BRIGHTNESS.
-OR-
3b Touch CONTRAST.
-OR-
3c Touch
BRIGHTNESS/CONTRAST
(for Ultraview 1500 only).
4 Use arrow keys to adjust.
To set the QRS tones (UCW and
Ultraview 1700):
1 Touch MONITOR SETUP.
2 Touch PRIVILEGED ACCESS.
3 Enter Clinical password.
4 Touch ALARM SETUP.
5 Touch MORE.
6 Select QRS/SPO2 TONE
ENABLE ALWAYS or
QRS/SPO2 TONE ENABLE
DURING ALARM.
To adjust the scaled display:
1 Touch MONITOR SETUP.
2 Touch MONITOR CONFIG.
3 Touch MINOR GRATICULE.
4 Select MINOR GRATICULE
ON.
5 Use arrow keys to adjust.