User's Manual

Ultraview Care Network
4-10
The PrintMaster will beep every 15-seconds under the following conditions:
• Paper jam
• Missing toner cartridge
• Top cover or back door open
• Power to printer is OFF
• Power cord is disconnected
• Printer cable is disconnected
• Printer in Not Ready mode
ERROR PRINT OVERRUN
Data too complex for current RASTER BUFFER setting.
Increase RASTER BUFFER value and resend job or add
memory. Press RECOVER to continue.
ERROR HOST I/F
Host interface error. Data was lost. Press RECOVER to
continue, and resend job.
CARD NOT FOUND PLEASE REINSERT
Font card removed. Reinstall card. Press RECOVER to
continue, and resend job.
ERROR PAPER SIZE CHECK ttttttt
Incorrect paper size detected for tray ttttttt. Provide correct
paper size and press RECOVER to continue.
PAPER INPUT JAM CHECK ttttttt
Paper jammed while being supplied from tray ttttttt. Clear jam
and open/close top cover.
PAPER FEED JAM CHECK tttttttt
Paper jammed during feeding from tray tttttttt. Clear jam and
open/close top cover.
PAPER EXIT JAM REMOVE THE PAPER Paper jammed during exit. Clear jam and open/close top cover.
COVER OPEN Close cover.
EEPROM RESETTING EEPROM resetting to factory defaults; returns to ON-LINE.
ERROR CARD FORMAT CHECK Installed font card has invalid data. Turn off printer to clear error.
ERROR CARD REMOVED ON-LINE Font card removed while ON-LINE. Turn off printer to clear error.
ERROR CONTROLLER nn
On -aaaaaaaa
Controller error, nn = error type. Power off printer to clear error.
If error continues, contact your Customer Service
Representative.
88888888
88888888
Displayed when power is turned on. This is done to test all LEDs
and LCD segments.
INITIALIZING Controller is being initialized at power ON.
RESET TO SAVE
Press RESET to save menu changes. Menu changes cannot be
reset automatically because data is present in buffer.
Table 2: Printer Display Messages (continued)
Message Text Reason