User's Manual

System Introduction and Network Basics
1-11
Full Bed Review - UCW and
Ultraview 1700 Only
The Full Bed Review (FBR) key allows you to view several parameters from
another monitor at your bedside or central station monitor. The monitor at which
the Full Bed Review is enabled will display all available parameters from the
remote monitor within the limitations of the capabilities of the displaying monitor.
Whenever a bedside or central monitor is displaying another monitor’s data, an
FBR key appears in the lower left corner if no menus are displayed. Full Bed
Review can be activated by touching this FBR key, then selecting one of the
flashing parameter keys. If the monitor is not displaying another monitor’s data,
Full Bed Review can be activated by touching the FBR key that follows the last
parameter icon for the selected bed.
If more parameters are available from the remote bedside than FBR can display,
keys for these additional parameters are displayed as numeric keys along the
bottom of the screen. Selecting any of these numeric keys causes the selected
parameter to replace the lowest parameter.
The parameter keys displayed by FBR are interactive. To access the controls for a
parameter, touch that parameter’s key. Remote review of trended or calculated
data for the selected monitor is available by touching the TRENDS/CALCS key
found in the Special Functions menu.
To deactivate the FBR feature, touch NORMAL SCREEN.
!
• Full Bed Review displays a single ECG lead if the remote
bedside is configured to display ECG data using the Full View or
Split View format.
To activate Full Bed Review at a
bedside monitor when a remote
view is not displayed:
1 Touch SPECIAL FUNCTIONS.
2 Touch REMOTE VIEW.
3 Select one of the subnet icons,
then select a bed icon.
4a Touch the FBR key displayed
after the last parameter icon for
that bed.
-OR-
4b Select any parameter icon,
then perform the steps in the
following Quick Start.
To activate Full Bed Review
when a remote parameter is
already displayed:
1 Touch NORMAL SCREEN, if
needed, to display all
parameters.
2 Touch FBR displayed in the
lower-left corner of the monitor.
3 Touch the flashing parameter
key of the selected remote bed.
To activate Full Bed Review at a
central monitor without
parameters already displayed:
1 Touch MONITOR SETUP.
2 Touch SCREEN FORMAT.
3 Select one of the subnet icons,
then select a bed icon.
4a Touch the FBR key displayed
after the last parameter icon for
that bed.
-OR-
4b Select any parameter icon, and
select a display zone to assign
that parameter to that display
zone.
5 Follow the steps in the previous
Quick Start.
To deactivate the Full Bed
Review:
1 Touch NORMAL SCREEN.