User's Manual

Ultraview Care Network
7-8
Parameter Configurations
ECG
Heart rate alarms can be set to fixed values or based upon the patient’s learned
heart rate. The learned heart rate is known as a result of ECG monitoring. If the
learned option is selected, you must specify high and low offset values. The high
and low rate alarm limits specify boundaries of the maximum available settings.
To automatically set heart rate alarms to:
• 40 beats above and 40 beats below the patient's learned heart rate.
• not to exceed a high rate of 200 and a low rate of 30.
Adjust the default settings as follows:
When selecting the fixed option, you only need to adjust the high and low rate
settings.
Heart rate alarms can be set independently for the adult mode and the infant
mode.
In the infant mode, you can select a delay between the time of initiation of
monitoring and alarm activation (0- to 3-minutes). This provides a period of time
for the patient to calm down after electrode application.
ST alarms can be set to identify regional and global changes. Specific leads can
be selectively included or excluded to provide more specific information.
The Check Setup feature provides a visual and audible prompt for you to assess
the patient setup before initiating monitoring or following a monitor reset or ECG
module change. You can disable this feature by setting it to OFF.
If you do not want to suspend ECG processing or disable ECG alarms, set the
CONTROL setting to OFF.
Type Learned
HIGH RATE 200
LOW RATE 30
HIGH RATE OFFSET 40
LOW RATE OFFSET 40
To review or change settings:
1 Touch ECG.
2 Touch SETUP.
3 Touch CONFIG.
4 Touch the hidden key 3 times.
5 Touch USER SETTINGS.
6a Select ECG.
-OR-
6b Select RESP.
-OR-
6c Select VARITREND.
-OR-
6d Select PRESSURE.
-OR-
6e Select SPO2.
-OR-
6f Select NIBP.
-OR-
6g Select TEMP.
7 Use CURSOR↑ and CURSOR↓
to scroll through the parameter
description list.
8 Use ↑ and ↓ to change the
settings.
9 Touch NEXT PAGE to continue
to next screen of parameters.
10 Touch STORE to save the new
settings.
11 Touch YES when the STORE
ALL CHANNEL DEFAULTS
message is displayed