User's Manual

Central Monitors
6-5
Central Monitor Features
Selecting Parameters for Display
Use the SCREEN FORMAT key in the Monitor Setup menu to assign remote
parameters to specific display zones and to choose the color of those zones.
Names of the subnet and bedside keys are assigned by your system
administrator.
One to 8 waveform zones may be displayed across the entire screen. Split screen
central monitors may display 16 waveform zones, with 1 at the top, left zone on
the display, and zone 9 appearing in the 1st zone upper right.
Figure 6-2: Central display - Screen Format menu
RESTORE COLORS — restores the last stored color settings from memory.
FACTORY DEFAULTS — restores the zone colors to the factory color setting of
white.
OVERWRITE ZONE — replaces a zone that has already been assigned a
parameter. Select the new parameter and then touch OVERWRITE ZONE to drop
the previously assigned parameter channel and replace it with the new parameter.
INSERT ZONE — moves the assigned zone and all other zones immediately
adjacent to the assigned zone down one zone, and the new zone is inserted
above them. If this causes an assigned zone to disappear from the screen, a
warning box will appear prompting you to complete or cancel the insert.
CLEAR ZONE — clears the zone assignment and returns the zone to an
unassigned state. Touch CLEAR ZONE, then touch the zone from which you wish
to remove an assignment.
To select remote parameters for
display:
1 Touch MONITOR SETUP.
2 Touch SCREEN FORMAT.
3 Select a bed (or a subnet, then
a bed).
4 Select the parameter(s) to be
displayed.
5 Select a zone.
To assign color to a zone:
1 Touch MONITOR SETUP.
2 Touch SCREEN FORMAT.
3 Touch the desired color.
4 Touch the zone to be colored.