User's Manual
Table Of Contents
- Introduction
- About the Transmitters
- ECG and SpO2
- ECG Overview
- Patient Preparation and Electrode Application
- To Set Up ECG Monitoring
- ECG Problem Solving
- SpO2 Overview
- Warnings and Cautions for SpO2
- Setting Up SpO2 Monitoring
- Ensuring Accurate SpO2 Monitoring
- SpO2 and Pulse Rate Specifications
- Using the Sensorwatch Feature
- Enabling and Adjusting Alarms
- Data Averaging
- Display Details at the Host Monitor
- Printing SpO2 Waveforms
- SpO2 Messages at the Host Monitor
- SENSOR DISCONNECTED — Check connection at adapter cable
- SENSOR OFF PATIENT — Check connection at patient
- INSUFFICIENT SIGNAL — Reposition or replace sensor
- LOW SIGNAL STRENGTH — Reposition or replace sensor
- AMBIENT LIGHT INTERFERENCE — Cover sensor area
- NOISY SIGNAL
- FAULTY SENSOR — Replace sensor
- HARDWARE INCOMPATIBILITY — Contact service
- Sensors
- SpO2 Alarm Delays
- SpO2 Troubleshooting Guide
- Basic Operations
- Getting Started
- Basic Components
- Selecting Options for Leads
- Basic User Actions
- Basic Modes of Operation
- View Mode
- Status Messages at the Host Monitor
- Telemetry Transmitter with ECG Only Troubleshooting Guide
- Telemetry Transmitter with Display Troubleshooting Guide
- Telemetry Transmitter with Display and SpO2 Troubleshooting Guide
- Cleaning, Disinfecting, and Sterilization
- Appendix A — Guidance and Manufacturer’s Declaration
- Appendix B — Symbols
www.spacelabshealthcare.com
1-3
TELEMETRY TRANSMITTER (96281)
I
NTRODUCTION
transmitter model. The 96281 telemetry transmitter does not
indicate any alarm conditions. Alarms are configured, generated,
and activated within the receiver-side components of the Ultraview
System only.
Note:
SpO
2
functionality is only available on the 96281-C telemetry
transmitter.
Manufacturer
The 96281 telemetry transmitter is manufactured by:
Relationship to Other Systems
The 96281 telemetry transmitter is related only to Spacelabs
Healthcare monitoring systems. Data collected by the transmitter
may be interfaced from the monitoring system to a hospital clinical
information system.
The telemetry transmitter is compatible with the list of receivers that
follow:
• Digital Telemetry System Receiver (90478) and Receiver
Housing (90479-A, 90479-B, 90479-C)
Refer to Bedside, Central, and Telemetry Systems CD-ROM and to
the Spacelabs Healthcare Service CD-ROM for information relating
to the 90478 and 90479 digital telemetry systems.
The 90478 receiver interacts with the Ultraview SL 91387-38 or
91387-39 central monitor, and with Ultraview SL patient monitors.
Note:
Not all products are available in all locales. Check with your local
Spacelabs Healthcare representative.
Spacelabs Healthcare
35301 SE Center Street
Snoqualmie, WA 98065
U.S.A.