User's Manual
Table Of Contents
- Introduction
- About the Transmitters
- ECG and SpO2
- ECG Overview
- Patient Preparation and Electrode Application
- To Set Up ECG Monitoring
- ECG Problem Solving
- SpO2 Overview
- Warnings and Cautions for SpO2
- Setting Up SpO2 Monitoring
- Ensuring Accurate SpO2 Monitoring
- SpO2 and Pulse Rate Specifications
- Using the Sensorwatch Feature
- Enabling and Adjusting Alarms
- Data Averaging
- Display Details at the Host Monitor
- Printing SpO2 Waveforms
- SpO2 Messages at the Host Monitor
- SENSOR DISCONNECTED — Check connection at adapter cable
- SENSOR OFF PATIENT — Check connection at patient
- INSUFFICIENT SIGNAL — Reposition or replace sensor
- LOW SIGNAL STRENGTH — Reposition or replace sensor
- AMBIENT LIGHT INTERFERENCE — Cover sensor area
- NOISY SIGNAL
- FAULTY SENSOR — Replace sensor
- HARDWARE INCOMPATIBILITY — Contact service
- Sensors
- SpO2 Alarm Delays
- SpO2 Troubleshooting Guide
- Basic Operations
- Getting Started
- Basic Components
- Selecting Options for Leads
- Basic User Actions
- Basic Modes of Operation
- View Mode
- Status Messages at the Host Monitor
- Telemetry Transmitter with ECG Only Troubleshooting Guide
- Telemetry Transmitter with Display Troubleshooting Guide
- Telemetry Transmitter with Display and SpO2 Troubleshooting Guide
- Cleaning, Disinfecting, and Sterilization
- Appendix A — Guidance and Manufacturer’s Declaration
- Appendix B — Symbols
www.spacelabshealthcare.com
4-14
T
ELEMETRY TRANSMITTER (96281)
B
ASIC OPERATIONS
• Pacing marker (shows only if detected) is shown as a vertical
purple line.
The symbols that follow show on the 96281-B and 96281-C telemetry
transmitter LCD when numerics are not available or are out of the
designated range for a parameter.
SpO
2
SpO
2
is only available with the 96281-C. SpO
2
data is obtained
directly from the patient and may show as in Figure 4-7, depending
on configuration of leads and available parameters.
The 96281-C auto-detects a sensor connection and activates or
deactivates the SpO
2
option accordingly.
Note:
SpO
2
view does not show if a SpO
2
adapter cable is not
connected.
Figure 4-7 Typical SpO
2
display on 96281-C (shows a low battery
state)
1 SpO
2
saturation percentage (96281-C only)
2 SpO
2
pulse waveform (96281-C only)
3 Battery charge indicator (defined by quartiles)
4 Signal quality/strength indicator (at least one color bar in
the indicator is recommended for a reliable SpO
2
value)
5 Pulse rate derived from SpO2 (indicated by an asterisk)
Not available ???
Under range - - -
Over range +++
4
1
2
5
3