User's Manual
Table Of Contents
- Volume III
- e. Technical Description Of Operation
- Fixed channel Mode
- Auto-select Channel Mode
- g. OEM radio card
- All three cards have a transmitting frequency range of 2.4 GHz to 2.4835 GHz with a transmitting power measured at the antenna of 100 milliwatts. The radio functions as a "frequency hopper" and by definition will "hop" between a preset range of frequenci
- h. Understanding Signal Interference
- Physical Obstructions and Communication Range
- RF Interference
- i. Coverage Area
- j. Possible Monitor & WNI Configurations
- k. Communication Limitations of the Wireless Network
- m. Installation Hardware
Again, back to our example. If the lowered throughput from WNI A is not attributable to transient causes
as listed above, WNI A may need to be relocated to an area where is will be out of range of the suspect
room. This will assure that a wireless monitor in the suspect room will synch to WNI B, where the
communications are better.
Remember that the effect of any change of WNI position must be evaluated from all rooms that can see
the WNI, not just the suspect room.
Part Number 062-0983-01 Rev C page 3 - 27