Instructions / Assembly

11
13
8
5
6
3
1
1
7L
7R
12
10
x3
x3
x4
2
STEP 1 STEP 2 STEP 3
STEP 4 STEP 5
x3
5
8
x5
4
4
x3
x3
9
9
5500V
PROFESSIONAL MANAGER’S CHAIR
ASSEMBLY INSTRUCTIONS
©OfceStarProductsAugust2009
PART QTY
1. Base .......................1
2. Casters .....................5
3. Pneumatic Cylinder ............1
4. Seat Plate ...................1
5. Seat Cushion .................1
6. Back Assembly ...............1
7. Arms (7L & 7R) ...............2
8. Arm Screws ..................6
9. Flat Washers .................6
10. Back Support Screws .........3
11. Seat Plate Screws ............4
12. Back Support (pre-installed) ....1
13. Allen Wrench ................1
Remove all parts from carton, separate by part numbers indicated on parts list, and verify part quantities.
STEP 1 InsertveCasters(2)intoBase(1),pushharduntilyoufeelorheartheCaster(2)snapintoplace.
STEP 2 AligntheholesintheArms(7L&7R)withtheholesintheSeatCushion(5),attachArms(7L&7R)toSeatCushion(5)usingthreeArmScrews(8)and
threeFlatWashers(9)foreachArm.FULLY TIGHTEN ALL ARM SCREWS (8) USING PHILLIPS SCREWDRIVER (not provided).
STEP 3AttachSeatPlate(4)toSeatCushion(5)withthearrowtowardsthefrontofthechair,secureusingfourSeatPlateScrews(11),
FULLY TIGHTEN ALL SEAT PLATE SCREWS (11) USING PHILLIPS SCREWDRIVER (not provided).
STEP 4AttachBackSupport(12)torearofSeatPlate(4)usingthreeBackSupportScrews(10).
FULLY TIGHTEN ALL BACK SUPPORT SCREWS (10) USING ALLEN WRENCH (13).
STEP 5 InsertPneumaticCylinder(3)intoBase(1),PlaceassembledseatontopofPneumaticCylinder(3)andapplydownwardpressure.
ATTENTION: MAKE SURE ALL SCREWS ARE FULLY TIGHTENED BEFORE USING CHAIR.
PhillipsScrewdriveralsoneededforassembly
(notprovided)