Instruction Manual

3. Slide the front trim piece out of the body nong
which channel it is contained within (for reng).
See Fig. G.
4. Slide the guard out of the body nong it is contained
within the same channel as the front trim piece.
See Fig. H.
5. If mulple ceramic emiers have to be replaced,
connue to slide the front trim pieces and guards
out of the body unl all ceramic emiers are
accessible nong the order in which the trims and
guards go. See Fig. J.
6. Locate the 2 × Phillips screws either side of the
ceramic emier and remove (ideally with a
magnec pped screwdriver which will also aid
reng) and take care to retain the spring/split
washers. See Fig. K.
7. Pull the reector holding the ceramic emier down
to expose the wiring (Fig. L). The ceramic emier
can be disconnected by rst pulling the sleeving
back to reveal the in-line connectors as shown in
Fig. M.

Fig. F
Fig. G
Fig. H
Fig. J
Fig. K
Fig. L
Fig. M