Full Product Manual

User’s Guide
24
Cleaning the Filter
1. Unplug the power pack from the electrical outlet.
2. Using the three caps provided, cap the
suction and discharge fi ttings on the
inside of the spa.
3. Open the air bleed fi tting on the top
of the fi lter tank.
4. Unscrew the retainer ring from the
fi lter housing and remove the fi lter
housing cover.
5. Lift the fi lter out of the fi lter housing.
Clean the fi lter with the spray from a
high pressure garden hose.
6. Place the fi lter back in the fi lter
housing. Make sure the fi lter is
properly seated in the housing and
that the o-ring is properly seated in
the o-ring groove.
7. Install the fi lter housing cover and
secure with the retaining ring. Tighten
the retaining ring hand-tight. Do not
over tighten the retaining ring.
8. Remove the caps from the spa suction
and discharge fi ttings inside the spa.
9. Open the air bleed fi tting on the top of the fi lter housing. Leave the
bleed fi tting open for one minute, or until water drips from the bleed
fi tting. Close the bleed fi tting.
10. Plug the power pack into the electrical outlet.
11. Reset the desired temperature set point.
Retaining
Ring
O-Ring
Groove
O-Ring