Full Product Manual

Comfort Line Products, Inc.
17
4. Bleed the air from the fi lter tank by
turning the small black knob on the
top of the fi lter tank counterclockwise.
Allow the fi lter tank to bleed for
approximately one minute, or until
water drips from the fi tting. Turn the
fi tting clock-wise to close the bleed
valve.
Plug the spa into a properly grounded electrical outlet.
5. Plug the power pack into the electrical outlet.  e water pump will
turn on and begin pumping water. Water should fl ow from the
small return nozzle on the bottom inside wall of the spa behind the
power pack. If water is not fl owing from the return nozzle, repeat
the air bleeding instructions provided in step 4. Unplug the power
pack while bleeding air.
NOTE: If the air is not properly bled from the fi lter tank,
the water pump will be air bound and no water will
fl ow. This will prevent the spa from heating, and
the water will not be fi ltered. Make sure water is
fl owing from the return nozzle before continuing.
6. Place the infl atable
bladder cover on the spa.
Make sure the cover is
centered on the spa.