Platinum Series Steakhouse Broiler User Manual

OWNER’S MANUAL 1190950 REV 2 (11/14)
PAGE
17
OF 22
STEAKHOUSE BROILER TROUBLESHOOTING
Figure 6
Access to Serviceable Parts
ACCESS TO SERVICEABLE PARTS
Some serviceable parts are only accessible by removing body side panels or the burner cover.
The burner cover is fastened with ten sheet-metal screws. To remove the burner cover, remove these screws. The burner
cover can then be pulled forward and removed. Each body side panel is fastened with seven sheet-metal screws, three in
the front and four at the rear. Remove body-side screws and slide the body side towards the rear and away from the unit
ADJUSTMENT OF BROILER PILOTS
The pilots are adjusted at the factory. If later the pilots are over-adjusted to the point where the ame is leaving its port, or
“blowing off,” the result is an unstable condition in which the pilot may extinguish. If necessary, adjust the pilots using the
following procedure:
1. If necessary, light the pilots.
2. Locate the pilot adjustment screw (which adjusts all pilots). It is a small slotted screw located on the pilot valve, and
can be adjusted though an access hole in the burner cover (shown in Figure 6 above).
3. Turn the pilot adjustment screw to adjust the size of the pilot ames. The ame on each pilot should be large enough
to extend along the ame carrier to the burner surface.
ADJUSTMENT OF BROILER BURNERS
The burners are adjusted at the factory. Adjustment may be required to achieve proper operation due to elevation change
or other variables. Remove the burner cover to adjust the air shutter on each burner venturi (shown in Figure 6) to
achieve proper combustion and optimum burn.
Burner Cover
P
ilot Adjustment
Screw
Body Side Panel
Burner Venturi